PS 311. FINISH CONTROL

PS 311. FINISH CONTROL
Flaw detection aerosol
Flaw detection aerosol has showing the defected surface aria had been coated with such as plasters, prime-filler coatings, etc. The PS311. FINISH CONTROL  applied after the each one new layer coatings as soon as a new coating layer have been done, dry and degreased totally!  The PS311. FINISH CONTROL has to be used through the whole abrasive grinding process. For repair and totally new coatings.

   For professional use only
   Fast drying
   Working with whole kind of finish and primer coatings
   Simply use aerosol and end up with very professional results
   Easy to abrasive
   Handy aerosol packaging has allowed to apply the PS311. FINISH CONTROL within hard frameworks

Directions to use:
1.    Shake the container well, approximately for two minutes by. Hold the can 10 to 12 inches away from the surface, pointing the nozzle toward the coating area and spray
2.    Working aria must be dry, clean and degreased totally!
3.    Spray the PS311. FINISH CONTROL with one thin layer only
4.    Abrasive after drying


General transport and storage conditions:
   This material and its container must be disposed of in a safe way.
   If swallowed, seek medical advice immediately and show this container or label.
   Use only in well-ventilated areas.

Additions:
Pressurized container: protect from sunlight and do not expose to temperatures exceeding   50°C.
   Do not pierce or burn, even after use.
   Do not spray on a naked flame or any incandescent material.
   Keep away from sources of ignition - No smoking.
   Keep out of the reach of children.

Shelf time:
at least 24 month.

To be supplied:
aerosol 500ml.